Setting up the camera in the barn
1.Use the clamping base or the permanent bracket to mount the camera, the clamping base can be clamped on any pole or board which is less than 2 ¼” diameters thick. Choose the mounting spot (As high as it is allowed) and tighten the clip bolt on the clamping base.
2. Plug the 110 /240V AC adapter into the power outlet and to the camera.
3. Attach the antenna 5 pins connector to the camera, tighten the pin screw.
4. Loose the tilt lock knob, adjust the camera, point it in the direction where you wish to
monitor, tighten the tilt lock knob.
5. Position the camera booster antenna (outdoor preferred) as high as possible. The
antenna has a magnet base, you may stick it any steel face. Or you can mount it
permanently with a screw.
6. Arrange the antenna cable neatly.
Setting up the monitor in the house or office
1. Attach the monitor to the desktop mounting bracket.
2. Attach the 7 pins connector antenna to the monitor.
3. Position the monitor booster antenna (outdoor preferred) as high as it is allowed. The
antenna has a magnet base, you may stick it to any steel surface. Or you can mount it
permanently with a screw.
4. Plug the 110 /240V AC adapter into the power outlet and monitor.
5. To turn on the monitor—Press the “POWER” button.
6. Switch to the correct channel, coordinate with your camera’s channel. To switch
channel- Press the “CH” (Channel) button , cycle through the channels. There are 8
channels to cycle through. Once the correct channel is found, the screen will show the
object you are monitoring.
7. Arrange the monitor power wire and the antenna cable neatly
|
